Seahorse Mito Stress Test Parameters
What Each Derived Parameter Assumes
| Parameter | Computation | Assumption |
|---|---|---|
| Basal respiration | Rate before injections, minus non-mitochondrial | Non-mitochondrial rate measured after rotenone/antimycin |
| ATP-linked | Basal minus oligomycin rate | Oligomycin blocks ATP synthase completely |
| Maximal | Rate after uncoupler | Uncoupler is at a concentration giving true maximum without damage |
| Spare capacity | Maximal minus basal | Both measured under the same substrate conditions |
| Proton leak | Oligomycin rate minus non-mitochondrial | The same non-mitochondrial assumption |
| Coupling efficiency | ATP-linked divided by basal | Basal is not dominated by non-mitochondrial oxygen consumption |
Important distinction. Every derived parameter depends on the non-mitochondrial rate measured at the end. If rotenone and antimycin do not fully block, or if the cells have a high residual oxygen consumption, every parameter inherits that error.
Part 1 — Before the Run
| Parameter | Starting point | Note |
|---|---|---|
| Seeding density | Titrate; aim for 70–90% confluence at assay | Too dense gives local hypoxia and nonlinearity |
| Attachment time | 4–24 h, consistent | Attachment stress changes basal rate |
| Assay medium | Bicarbonate-free, HEPES, with defined substrates | Substrate mix sets basal rate |
| Substrate choice | Glucose ± pyruvate ± glutamine | Each changes the answer; state it |
| Equilibration | 45–60 min at 37 °C, no CO₂ | Removes bicarbonate |
| Final volume | Per plate format | Affects diffusion and injected concentration |
Caveat on substrate choice. Basal respiration in glucose-only medium differs substantially from glucose plus glutamine, because glutamine supplies anaplerotic carbon and can be oxidised. Comparisons across laboratories that used different substrate mixes are not comparisons of the same quantity.
Part 2 — Injection Concentrations
| Injection | Typical | Titrate? | Note |
|---|---|---|---|
| Oligomycin | 1–2 µM | Yes | Incomplete blockade inflates ATP-linked estimates |
| FCCP | 0.5–2 µM | Yes, essential | Optimum varies several-fold between lines |
| Rotenone + antimycin A | 0.5–1 µM each | Sometimes | Residual oxygen consumption should be low |
Important distinction. The uncoupler titration is not optional. FCCP has a narrow optimum: below it, respiration is submaximal; above it, the inner membrane becomes leaky in a non-physiological way and respiration falls. A single concentration taken from another paper can under- or over-estimate maximal respiration by a large margin, and the direction of the error is not predictable.
Part 3 — Cycles and Normalisation
| Setting | Typical | Why |
|---|---|---|
| Mix | 3 min | Equilibrates the well |
| Wait | 2–3 min | Sensor stabilisation |
| Measure | 3 min | Averaged rate |
| Replicates | 3–5 wells | Well variance dominates small effects |
| Baseline cycles | 3 | Stability check; more than 10% variation is a red flag |
| Post-assay normalisation | Cell count, protein or DNA | OCR otherwise tracks seeding |
Readout note. Normalisation changes conclusions more often than expected. In a treatment that reduces cell size or protein content, protein normalisation inflates the per-cell effect; in a treatment that changes proliferation, well-based normalisation confounds the result with cell number. Reporting both a per-well value and a normalised value makes the dependence visible.
Part 4 — Interpreting Unusual Patterns
| Pattern | Interpretation |
|---|---|
| Basal equals maximal | Cells are already at capacity; uncoupler adds nothing |
| Maximal below basal | Uncoupler toxicity, or a titration problem |
| Very high proton leak | Membrane damage, or a genuinely uncoupled state |
| Negative spare capacity | Maximal below basal; usually a technical failure |
| Non-mitochondrial fraction large | Incomplete inhibition, or high residual oxygen consumption |
The first row is a real and informative finding: cells operating at maximal respiratory capacity have no reserve, which is a metabolic state, not an assay failure.
Part 5 — Common Failures
- • Uncoupler not titrated.
- • Oligomycin assumed complete at a single concentration.
- • Substrate mix unrecorded.
- • Seeding density copied from another line.
- • Edge wells included without a layout control.
- • Normalisation basis not stated.
- • Rotenone/antimycin residual respiration ignored.
- • Assay medium containing serum, which alters both substrate supply and buffering.
- • Rates reported from a single well, without replicates.
Part 6 — Where This Article Connects
This is the instrument article for the mitochondrial cluster, and it implements the readouts that the respiratory chain article describes conceptually. The baseline troubleshooting article in the glucose cluster covers unstable traces; the membrane potential article covers coupling measured by a different method.
If you need mitochondrial stress tests with uncoupler titration and substrate control, we can scope the work with you.
Contact EDITGENE to request a project consultation or quote.
Scientific scope and validation note
Optimal density, uncoupler concentration and substrate mix vary by cell type and plate format; the values here are starting points requiring local titration.
Derived parameters depend on the completeness of inhibitor blockade and on the non-mitochondrial rate, and they describe assay conditions rather than the intact cell's physiology.
Scientific interpretation and experimental design
- • Titrate the uncoupler. A single dose is a guess.
- • Check oligomycin. Incomplete blockade inflates ATP-linked.
- • State the substrate mix. It sets the baseline.
- • Non-mitochondrial rate propagates. Measure it properly.
- • Normalise, and state how.
- • Basal equal to maximal is a finding.
Selected references for further reading
- • Brand MD, Nicholls DG. Assessing mitochondrial dysfunction in cells. Biochemical Journal. 2011;435:297–312.
- • Divakaruni AS, Jastroch M. A practical guide for the analysis, standardization, and interpretation of oxygen consumption measurements. Nature Metabolism. 2022;4:978–994.
- • Mookerjee SA, et al. Quantifying intracellular rates of glycolytic and oxidative ATP production and consumption using extracellular flux measurements. Journal of Biological Chemistry. 2017;292:7189–7207.
Related Services
Related Products
| Product name | Cat.No. | Species | Gene ID | |
|---|---|---|---|---|
| PBRM1 Knockout A-549 Cell Line | EDJ0001-K01 | Human | 55193 | Details Get a Quote |
| YTHDC1 Knockout A-549 Cell Line | EDC07652 | Human | 91746 | Details Get a Quote |
| TP53 Knockout HCT 116 Cell Line | EDC07854 | Human | 7157 | Details Get a Quote |
| Sirt2 Knockout MH-S Cell Line | EDJ-KQ78173 | Mouse | 64383 | Details Get a Quote |
| TFE3 Knockout KGN Cell Line | EDJ-KQ48 | Human | 7030 | Details Get a Quote |
| Stub1 Knockout MB49 Cell Line | EDJ-KQ53 | Mouse | 56424 | Details Get a Quote |
| ARID1A Knockout SNK-6 Cell Line | EDJ-KQ64 | Human | 8289 | Details Get a Quote |
| Tet1 Knockout Kupffer Cell Line | EDJ-KQ88 | Mouse | 52463 | Details Get a Quote |
| NR1H3 Knockout HEK293T Cell Line | EDJ-KQ109 | Human | 10062 | Details Get a Quote |
| NR1H2 Knockout HEK293T Cell Line | EDJ-KQ110 | Human | 7376 | Details Get a Quote |
| RPS6KB2 Knockout HEK293 Cell Line | EDJ-KQ125 | Human | 6199 | Details Get a Quote |
| SMAD6 Knockout HEK293 Cell Line | EDJ-KQ126 | Human | 4091 | Details Get a Quote |
| JUN Knockout HEK293 Cell Line | EDJ-KQ176 | Human | 3725 | Details Get a Quote |
| JUN Knockout HEK293T Cell Line | EDJ-KQ184 | Human | 3725 | Details Get a Quote |
| ALKBH5 Knockout HEK293 Cell Line | EDJ-KQ186 | Human | 54890 | Details Get a Quote |
- 1
- 2
- ...
- Next Page »